Whirlpool WGD9050X User Manual

To reduce the risk of fire, this dryer MUST BE 

EXHAUSTED OUTDOORS.

Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent, 

chimney, wall, ceiling, attic, crawlspace, or a concealed space 

of a building. Only rigid or flexible metal vent shall be used for 

exhausting.

Recommended for best drying performance and to prevent 

 

■

crushing and kinking.

(Acceptable only if accessible to clean)

Must be fully extended and supported in final dryer location.

 

■

Remove excess to avoid sagging and kinking that may 

 

■

result in reduced airflow and poor performance.

Do not install in enclosed walls, ceilings, or floors.

 

■

The total length should not exceed 7 

 

■

3

/

4

 ft. (2.4 m).

If using an existing vent system, clean lint from entire 

length of the system and make sure exhaust hood is not plugged 

with lint. Replace plastic or metal foil vents with rigid metal or 

flexible metal vents. Review Vent system chart and if necessary, 

modify existing vent system to achieve best drying performance.

Only a 4" (102 mm) heavy metal exhaust 

 

■

vent and clamps may be used. 

Do not use plastic or metal foil vent.

 

■

Must be at least 12" (305 mm) from ground or any object 

 

■

that may obstruct exhaust (such as flowers, rocks, bushes, 

or snow).

45° elbows provide better airflow than 90° elbows.

 

■

 

Use clamps to seal all joints.

 

■

Exhaust vent must not be connected or secured with screws 

 

■

or other fastening devices that extend into interior of duct  

and catch lint. Do not use duct tape.

Moisture damage to woodwork, furniture, paint, wallpaper, 

carpets, etc.
Housecleaning problems and health problems.

Vent products can be purchased from your dealer. For more 

information, see “Assistance or Service” section in your Use and 

Care Guide.