Whirlpool WGD9050X User Manual

       Not Level 

            

LEVEL                    Not Level

Check levelness of dryer from side to side. Repeat from  

front to back. 

NOTE: The dryer must be level for the moisture sensing system 

to operate correctly.

Place 

level here

If dryer is not level, prop up using a wood block, use wrench  

to adjust legs up or down, and check again for levelness. 

Once legs are level, make sure all four legs are snug against 

the ground before tightening them.

Using a 4" (102 mm) clamp, connect vent to exhaust outlet  

in dryer. If connecting to existing vent, make sure vent is 

clean. Dryer vent must fit over dryer exhaust outlet and inside 

exhaust hood. Check that vent is secured to exhaust hood 

with a 4" (102 mm) clamp.

Move dryer to final location.  Avoid crushing or kinking vent. 

After dryer is in place, remove corner posts and cardboard 

from under the dryer.