Whirlpool gew9250s User Manual

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here. 

Remove parts packages from dryer drum. Check that all parts are 
included.

■

Parts package

NOTE: Do not use leveling legs if installing the dryer on a 
pedestal.

Check local codes. Check existing electrical supply and venting.  
See “Electrical Requirements” and “Venting Requirements” 
before purchasing parts.

■

For close-clearance installations between 31.5" (80.01 cm) 
and 37" (93.98 cm), see “Plan Vent System” section for 
venting requirements.

Mobile home installations require metal exhaust system hardware 
available for purchase from the dealer from whom you purchased 
your dryer. For further information, please refer to the “Assistance 
or Service” section of this manual.

Are you placing the dryer on a pedestal? You have the option of 
purchasing pedestals of different heights separately for this dryer. 
You may select a 10" (25.4 cm), a 13" (33 cm) or a 15.5" (39.4 cm) 
pedestal. These pedestals will add to the total height of the dryer 
for a total height of approximately 48" (121.9 cm), 51" (129.5 cm) 
or 53.5" (135.9 cm), respectively.

For a garage installation, you will need to place the 10" (25.4 cm) 
pedestal at least 9" (22.9 cm) above the floor and the 13" (33 cm) 
pedestal at least 6" (15.2 cm) above the floor. You will need to 
place the 15.5" (39.4 cm) pedestal at least 3.5" (8.9 cm) above 
the floor.   

The pedestals are available in several colors. 

To order, call the dealer from whom you purchased your dryer or 
refer to the “Assistance or Service” section of this manual. 

Are you planning to stack your DUET

®

 washer and dryer? To do 

so, you will need to purchase a Stack Kit.

To order, call the dealer from whom you purchased your dryer or 
refer to the “Assistance or Service” section of this manual. Ask 
for Part Number 8541503.

■

Flat-blade screwdriver

■

#2 Phillips screwdriver

■

Adjustable wrench that 
opens to 1" (2.5 cm) or 
hex-head socket wrench 
(for adjusting dryer feet)

■

Wire stripper (direct wire 
installations)

■

Level

■

Vent clamps

■

Caulking gun and 
compound (for installing 
new exhaust vent)

■

Tin snips (new vent 
installations)

■

¼" nut driver 
(recommended)

■

Tape measure

White

WHP1000SQ

Biscuit

WHP1000ST

Pewter

WHP1000SL

Diamond Dust 
(Silver)

WHP1000SU

White

LAB2700MQ

Biscuit

LAB2700MT

Pewter

LAB2700ML

White

WHP1500SQ

Biscuit

WHP1500ST

Pewter

WHP1500SL

Diamond Dust 
(Silver)

WHP1500SU