Bunn FMD-3 User Guide

Page of 42
4
INITIAL SET-UP
1.  Locate the drip tray assembly above the dispenser nested in the packing material.
2.  Remove  the drip tray and the drip tray cover and set them aside.
3.  Remove the water strainer assembly from the drip tray and set it aside.
4.  Remove the four legs from the packaging material, apply non-skid pads to the bottom of the legs  and securely 
install the legs in the dispenser base.
29170 090407
ELECTRICAL REQUIREMENTS
Refer to Data Plate on the dispenser, and local/national electrical code to determine circuit requirements.
CAUTION - The dispenser must be disconnected from the power source until specified in Initial Set-Up.
The 120 volt version of this dispenser has an attached cordset. The mating connector must be a NEMA 5-15R.
The 120/208 volt and the 120/240 version of this dispenser has an attached cordset. The mating connector must 
be a NEMA 14-20R.
The 230 and 240 volt versions of this dispenser has an attached cordset without plug.
ELECTRICAL HOOk-UP
CAUTION
 - 
Improper electrical installation will damage electronic components.
1.  An electrician must provide electrical service as specified.
2.  Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.
3.  Open the front door of the dispenser and place the heater switch in the “OFF” (upper position).
4.  Connect the dispenser to the power source. 
5.  If plumbing is to be hooked up later be sure the dispenser is disconnected from the power source.  If    
plumbing has been hooked up, the dispenser is ready for Initial Fill & Heat.
CE REQUIREMENTS
•  This appliance must be installed in locations where it can be overseen by trained personnel.
•  For proper operation, this appliance must be installed where the temperature is between 0°C to 35°C.
•  Appliance shall not be tilted more than 10° for safe operation.
•  An electrician must provide electrical service as specified in conformance with all local and national codes
•  This appliance must not be cleaned by water jet
•  This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given instructions concern-
ing use of this appliance by a person responsible for its safety.