Bunn FMD-4 User Guide

36

FIG. 32 DISPENSE SOLENOID VALVE 

TERMINALS

P1672

Removal and Replacement:

1.  Remove the four #8-32 screws securing the side 

access panel to the housing. Remove panel and 

set aside.

2.  Remove the wires from the solenoid valve.

3.  Turn-off the water supply to the dispenser.

4.  Using the tank drain tube, drain enough water from 

the tank so the water level is below the dispense 

valve mounting hole.

5.  Disconnect  the  water  line  from  the  solenoid 

valve.

6.  Remove the  #8-32 keps nut securing the solenoid 

valve bracket to side of the tank. Remove solenoid 

valve. 

7.  Install new solenoid valve and o-ring on side of 

the tank and secure in place with valve mounting 

bracket and #8-32 keps nut.

8.  Push the water line onto the tube on bottom of 

solenoid valve.

9.  Refer to Fig. 32 and reconnect the wires.

10. Reinstall side access panels.

WHIto Main Harness

TAN to Main Harness Station #1

RED to Main Harness Station #2

ORN to Main Harness Station #3

YEL to Main Harness Station #4

BLU to Main Harness Station #5

35135 012103