LG KA80610F Owner's Manual

• A device must be provided in the electrical installation which

allows the appliance to be disconnected from the mains at all
poles with a contact opening width of at least 3 mm Suitable
isolation devices include line protecting cut-outs, fuses (screw
type fuses are to be removed from the holder), earth leakage trips
and contactors.

• In respect of fire protection, this appliance corresponds to type

Y (EN 60335-2-6). Only this type of appliance may be installed
with a high cupboard or wall on one side.

• Drawers may not be fitted underneath the hob.

• The installation must guarantee shock protection.

• The kitchen unit in which the appliance is fitted must satisfy the

stability requirements of DIN 68930.

• For protection against moisture, all cut surfaces are to be sealed

with a suitable sealant.

• On tiled work surfaces, the joints in the area where the hob sits

must be completely filled with grout.

• On natural, artificial stone, or ceramic tops, the snap action

springs must be bonded in place with a suitable artificial resin or
mixed adhesive.

• Ensure that the seal is correctly seated against the work surface

without any gaps. Additional silicon sealant must not be applied;
this would make removal more difficult when servicing.

• The hob must be pressed out from below when removed.

• Clean the work surface in the area of the cut-out.

• Sealing tape is mounted on the ceramic Glass initially.