LG 42LV555H Owner's Manual

11

206-4200

 

This section describes how to set up a Master TV for cloning purposes when the TV is in Pass-through 

Mode.
Note: Refer to FTG Mode information on pages 33 to 44 for details on entering FTG Mode and 

configuring/editing FTG Channel Map and FTG Installer Menu settings.

•  Disconnect all Aux inputs if you intend to run Auto Tuning (Channel Search). Under certain conditions, 

Auto Tuning is disabled if there is an Aux input active.

•  Determine which cloning tool—USB memory device or clone programmer—is appropriate for your  

application; several of the Master TV Setup procedure steps are dependent on the cloning tool to be 

used. See “Cloning Methods” below for further information.

•  If you intend to use a USB memory device, determine the type of file—either the new “.tlx” file format or 

the legacy “.tll” file format—to use for cloning purposes; several of the Master TV Setup procedure steps 

are dependent on the desired file type. See “Cloning Methods” below for further information.

Using a USB Memory Device / .tlx File 
•  The .tlx file format clones the following menu settings: Installer Menu settings, IP Environment Offset 

Setup and Pro:Centric Setup settings (see pages 45 and 46), and all TV sources’ (analog, digital, AV1, 

HDMI, etc.) clonable setup menu settings. See “Clonable TV Setup Menu Features” list below.

•  Not intended for cloning an auto-tuned/edited Channel Map, as the channel lineup is converted to a logical 

FTG Channel Map when saved (Learned) from a TV to a .tlx file. If the .tlx file with the FTG Channel Map 

is then used for Teaching purposes, all Target TVs will be configured for FTG Mode via CPU.

Using a USB Memory Device / .tll File
The .tll file format clones the contents of the commercial controller (PTC) memory, including an auto-tuned/

edited Channel Map, Installer Menu settings, and one TV source’s (analog, digital, or Aux) clonable setup 

menu settings. See “Clonable TV Setup Menu Features” list below.

Using a Clone Programmer (TLL-1100A or LT2002)
Both the TLL-1100A and LT2002 clone the contents of the commercial controller (PTC) memory, including 

an auto-tuned/edited Channel Map, Installer Menu settings, and one TV source’s (analog or Aux) clonable 

setup menu settings. See “Clonable TV Setup Menu Features” list below.

Channel  

  Auto Tuning (Channel Lineup)

  Manual Tuning

  Channel Edit 

  Channel Label

Picture 

  Aspect Ratio 

  Picture Mode 

 

Audio  

  Auto Volume  

  Clear Voice  

  Sound Mode  

  Balance

  TV Speaker 

Time  

  Auto Clock

  Auto Off (Sleep Timer) 

  Menu Language

Audio Language

  Caption  

Lock  

  Movie Rating  

  TV Rating – Children  

  TV Rating – General 

    

 

Note: Some menu options vary between analog and digital channels and Aux inputs.