LG 42LV555H Owner's Manual

12

206-4200

Typical Installer Menu

Note: The Installer Menu header will vary 

depending on the TV you are setting up. 

Adjust the settings for these 

Installer Menu items.

This step provides specific instruction only on the Installer Menu 

items that should be set on a Master TV. Refer to pages 15 to 22 

for detailed information on all Installer Menu items.

a) Make sure the TV is ON. Then, use the Installer Remote to  

enter the PTC Installer Menu: Press 

MENU repeatedly until 

the on-screen display of the TV setup menus no longer 

toggles, and then press 

9-8-7-6 + ENTER. 

b) Set Installer Menu item 

117 FACT DEFAULT to 001 and press 

ENTER on the Installer Remote. 
This clears all Installer Menu custom settings, channel lineup, 

etc. and reloads the factory default settings. The value will 

change back to 0 after the PTC has been restored to factory 

default condition. This step ensures that the TV Channel 

Memory will be the active channel lineup.

c) Set Installer Menu item 

003 BAND/AFC, as appropriate.

•  Broadcast: Set to 000.

•  HRC: Set to 002.

•  CATV: Set to 001 (default).

•  IRC: Set to 003. 

d) Set any other Installer Menu items that affect your TV pro-

gramming network to the required configuration. For example, 

enable/disable Aux 

inputs

, set a Start Channel, etc.

e) After you have adjusted all required Installer Menu item  

settings, press 

ENTER once on the Installer Remote to save 

your changes; then, press 

ENTER again to exit the menu.

On-screen setup menus control the features of the TV. Press 

MENU on the Installer Remote to access the TV setup menus, 

and then set Channel, Picture, Audio, Lock, Time, etc. options to 

the desired configurations. See also the Clonable TV Setup Menu 

Features list on page 11.
Note: If you intend to clone the PTC, remember that only one TV 

source’s clonable setup menu settings will be cloned. Thus, for a 

clone programmer, the TV setup menu settings should be applica-

ble to either an analog channel or Aux input, while for a USB 

device / .tll file, the TV setup menu settings should be applicable 

to the analog or digital channel or Aux input to which the Target 

TV will be set during the Teaching process. 
Note: If desired and if appropriate depending on the cloning 

method you intend to use (see “Cloning Methods” on previous 

page), you can run Auto Tuning (see step 3) prior to completing 

this step. 

(Continued on next page)

 

Use the TV setup menus to set the TV 

features to the desired configuration 

for the end user. 

PICTURE

AUDIO

INPUT

OPTION

TIME

USB

CHANNEL

LOCK