LG 42LV555H Owner's Manual

37

206-4200

1.  Plug the USB memory device that contains the FTG Configuration 

file into the Target LD660H/LD665H or LV555H TV USB IN port.

2.  Press 

MENU on the Installer Remote to display the TV setup 

menus (TV is in Pass-through Mode) or the Function Menu (TV is 

already in FTG Mode). 

3.  Use the arrow navigation keys to select/highlight either the 

Option 

menu icon from the TV setup menus or the 

Lock menu icon from 

the Function Menu. Then, press the number “

7” key a total of seven 

times to display the USB Download Menu.

4.  Use the Up/Down arrow keys to select 

Teach To TV (TLX), and then 

press 

ENTER.

5.  Use the Up/Down arrow keys to select the FTG Configuration file 

you want to install, and then press 

ENTER.  

    The TV will show Teaching completion progress in a new window. 

Do NOT remove the USB device until Teaching is complete. When 

Teaching is complete, the TV will tune to the first logical channel in 

the FTG Channel Map.

6.  When Teaching is done, remove the USB memory device. The 

FTG Configuration should be resident on the Target TV. Also, the 

Target TV CPU is now in FTG Mode (if it was previously in Pass-

through Mode).

Teach To TV (TLX)

xxLD660H-UA00005.TLX

Return

 

 

Enter

USB Download Menu

Upgrade TV Software
Upgrade PTC Software
Teach To TV (TLL)

Teach To TV (TLX)

Return 

 

Enter

Teach To TV

UPDATING...

Do not unplug!

!

50%

This procedure describes how to “Teach” an FTG Configuration file from a USB memory device to a TV. 

Ensure you have completed the procedure on the previous page to create the FTG Configuration file  

before proceeding with the steps below. 
Notes:  •  If the TV is not in FTG Mode, but both Pro:Centric items (098 PRO:CENTRIC and 119 DATA 

CHANNEL) have already been set in the Installer Menu on a TV, Teach to TV options will not 

be available from the USB Download Menu. 

•  If the TV EBL is already in FTG Mode, you cannot use this procedure to make changes to 

the FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-TV  

connection as described on page 40 or an FMA head end device to reconfigure the EBL.

•  If either of the preceding conditions applies, but you wish to switch the TV to FTG mode via 

CPU, refer to Reference section, “Resetting Factory Defaults on the TV(s),” for further  

information before proceeding.