LG 42LV555H Owner's Manual

39

206-4200

Typical Installer Menu

Note: The Installer Menu header will vary 

depending on the TV you are setting up. 

Use Channel Menu options to run 

Auto Tuning and edit the channel 

lineup, as necessary.

Adjust the settings for these 

Installer Menu items.

Set Installer Menu Items
These steps provide specific instruction only on the Installer Menu items 

that should be set on an LD660H/LD665H or LV555H TV. Refer to pages 

15 to 22 for detailed information on all Installer Menu items.
1.  Make sure the TV is ON. Then, use the Installer Remote to enter the 

Installer Menu: Press 

MENU repeatedly until the on-screen display of the 

TV setup menus no longer toggles, and then press 

9-8-7-6 + ENTER. 

2.  Set Installer Menu item 

117 FACT DEFAULT to 001 and press ENTER 

on the Installer Remote. 

    This clears all Installer Menu custom settings, the channel lineup, etc. 

and reloads the factory default settings. The value will change back to 

0 after the commercial controller (PTC) has been restored to factory 

default condition. This step ensures that the TV Channel Memory will be 

the active channel lineup.

3.  Set Installer Menu item 

003 BAND/AFC, as appropriate.

•  Broadcast: Set to 000.

•  HRC: Set to 002.

•  CATV: Set to 001 (default).

•  IRC: Set to 003. 

4.  Set any other Installer Menu items that affect your TV programming 

network to the required configuration. For example, enable/disable Aux 

inputs, set a Start Channel, etc. 

5.  After you have adjusted all required Installer Menu item settings, press 

ENTER once on the Installer Remote to save your changes; then, press 

ENTER again to exit the menu.

Run Auto Tuning (Channel Search) 
Note: In the FTG Configuration file, Logical Channel numbers will automati-

cally be assigned in ascending order, starting with 0 (zero), to the Physical 

Channels from the TV Channel Map.
Note: Pro:Idiom decryption for encrypted channels will not be enabled unless 

you use the FTG File Manager to set the channel attributes. 
1.  Search for all available analog and digital channels: Use the Installer 

Remote to go to the Channel Menu, select the 

Auto Tuning option, and 

follow the on-screen instructions.

2.  Use the 

Channel Edit option in the Channel Menu to edit the channel 

lineup, as necessary, to include free to guest channels only. Add/delete 

channels per your system requirements.  

The manual configuration procedures below should only be performed if you do not know the RF channels 

at the site and need to “Learn” an FTG Configuration file from an LD660H/LD665H or LV555H TV as 

described on the previous page. Ensure the TV is in Pass-through Mode before you begin.

Once you have completed these procedures, return to “Learning an FTG 

Configuration File from a TV” on the previous page to complete the Learn 

sequence.

Enter

Move

CHANNEL

Auto Tuning

Manual Tuning
Channel Edit
Channel Label