KitchenAid 30'' Slow Cook Warming Drawer Installation Guide

Page of 16
3
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.
Tools needed
 
Phillips screwdriver
 
Flat-blade screwdriver
 
Measuring tape
 
Level
 
Drill
 
1
3
/
8
" (3.5 cm) hole saw
Parts supplied
 
Two #8-18 x 
1
/
2
" screws
 
Lens (for panel ready models)
Check local codes. Check existing electrical supply. See 
“Electrical Requirements.”
It is recommended that all electrical connections be made by 
a licensed, qualified electrical installer.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
 
Cutout dimensions that are shown must be used. Given 
dimensions provide minimum clearance with warming 
drawer.
 
Recessed installation area must provide complete enclosure 
around the recessed portion of the warming drawer.
 
Grounded electrical supply is required. See “Electrical 
Requirements” section.
 
Electrical supply outlet should be located in the rear wall 
on the upper right-hand side of the cutout or in an adjacent 
cabinet. The outlet must be recessed. If the electrical outlet 
is located in an adjacent cabinet, a 1
3
/
8
" (3.5 cm) minimum 
diameter hole should have been drilled in the back of the 
cutout or support surface to pass the power supply cord 
through to the outlet.
 
Warming drawer support surface must be solid, level,and 
flush with bottom of cabinet cutout.
 
Warming drawers with oiled bronze, black glass, and white 
glass panels are approved for indoor use only.
 
Support surface must be solid, level, and flush with the 
bottom of the cabinet cutout.
 
24" (61.0 cm) minimum cabinet depth. 
For best performance results make sure the warming drawer is 
leveled before completing installation. There is no way to level 
the warming drawer after it has been installed. If the installation 
is not level, the door may slide open or not seal tightly, allowing 
heat to escape.
NOTE: If installing the warming drawer below another product, 
refer to that product’s literature for any installation requirements.
Product Dimensions
D
C
A
E
B
WARMING 
DRAWER 
SIZE
OVEN 
DEPTH (A)
RECESSED 
WIDTH (B)
RECESSED 
HEIGHT (C)
OVERALL 
WIDTH (D)
DRAWER 
FRONT 
HEIGHT (E)
24" (60.9 cm)
23
1
/
8
" (58.7 cm)
22
1
/
4
" (56.5 cm)
9" (22.9 cm)
23
3
/
4
" (60.3 cm)
10
1
/
4
" (26.1 cm)
27" (68.6 cm)
23
1
/
8
" (58.7 cm)
25
1
/
4
" (64.1 cm)
9" (22.9 cm)
26
3
/
4
" (67.9 cm)
10
1
/
4
" (26.1 cm)
30" (76.2 cm)
23
1
/
8
" (58.7 cm)
28
1
/
4
" (71.8 cm)
9" (22.9 cm)
29
3
/
4
" (75.6 cm)
10
1
/
4
" (26.1 cm)