KitchenAid 27" Double Wall Oven with Even-Heat™ True Convection Installation Instruction

 

■

Refer to the following “Installation Instructions” and 

the “Installation Instructions” section of the Installation 

Instructions provided with your built-in oven.

 

■

Refer and adhere to the “Electrical Requirements” 

section, and complete the instructions in the “Make 

Electrical Connection” section of the Installation 

Instructions provided with your built-in oven.

1.  Decide on the final location for the oven. Avoid drilling or 

cutting into house wiring during installation.

2.  To avoid floor damage, set the oven onto cardboard prior 

to installation. Do not use handle or any portion of the front 

frame for lifting.

3.  Remove the shipping materials and tape from the oven. 

Remember to keep the corner posts and other materials that 

may be needed for installation.

4.  Remove the hardware package from inside the bag 

containing literature.

5.  Move oven and cardboard close to the oven’s final location.

IMPORTANT: Use two hands to remove oven door(s).
1.  Prior to removing the oven door, prepare a surface where 

you will place it. This surface should be flat and covered with 

a soft blanket, or use the corner posts from your packaging 

material.

2.  Open the oven door.
3.  Locate the oven door hinge locks in both corners of the oven 

door, and rotate the hinge locks toward the oven door to the 

unlocked position. If the door hinge lock is not rotated fully 

(see illustration B), the door will not remove properly.

4.  Partially close the door to engage the door latch locks. The 

door will stop at this point.

5.  Using two hands, grasp the edges of the oven door. Lift and 

pull the oven door toward you, and remove. You may need to 

gently shift door from side to side as you pull.

6.  Set the oven door(s) aside on the prepared covered work 

surface with the oven door resting on its handle.

7.  To continue with the oven installation, go to the “Positioning 

Oven Feet” section.