Canon imageRUNNER ADVANCE C9075S PRO Manual
Remove the punch waste of the punch unit
Introduction
This section describes how to remove the punch waste.
#
IMPORTANT
•
Take care when handling the optional equipment that is attached to the machine.
When an optional unit's cover is opened to replace a staple cartridge, discard the
punch waste, discard the trim waste, or clear paper or staple jams, prints may still
be output if other optional units are operating normally and are not involved in
the paper or staple jam removal procedure.
When an optional unit's cover is opened to replace a staple cartridge, discard the
punch waste, discard the trim waste, or clear paper or staple jams, prints may still
be output if other optional units are operating normally and are not involved in
the paper or staple jam removal procedure.
•
When the punch waste tray is full, you cannot use the punching options.
#
NOTE
This procedure is necessary only if Puncher Unit-BG1/BH1/BF1 is attached.
Remove the punch waste of the punch unit
1.
Open the front cover of the finisher.
Chapter 9 - Paper, toner, and staples
293
Remove the punch waste of the punch unit