Canon imageRUNNER ADVANCE C9075S PRO Manual
Replace the staple cartridge in the saddle stitch unit
Introduction
This section describes how to replace the staple cartridge in the saddle stitch unit of
Booklet Finisher-A1.
Booklet Finisher-A1.
#
IMPORTANT
•
•
Take care when handling the optional equipment that is attached to the machine.
When an optional unit's cover is opened to replace a staple cartridge, discard the
punch waste, discard the trim waste, or clear paper or staple jams, prints may still
be output if other optional units are operating normally and are not involved in
the paper or staple jam removal procedure.
When an optional unit's cover is opened to replace a staple cartridge, discard the
punch waste, discard the trim waste, or clear paper or staple jams, prints may still
be output if other optional units are operating normally and are not involved in
the paper or staple jam removal procedure.
•
If necessary, remove all the output paper in the booklet tray before replacing the
staple cartridge in the saddle stitcher unit.
staple cartridge in the saddle stitcher unit.
•
This procedure is necessary only if Booklet Finisher-A1 is attached.
#
NOTE
Since both the front and inner staple cartridges need to be replaced when staples run
out in the saddle stitcher unit, we recommend that you order staple cartridges from
your local authorized dealer before your stock runs out.
out in the saddle stitcher unit, we recommend that you order staple cartridges from
your local authorized dealer before your stock runs out.
Replace the staple cartridge in saddle stitch unit
1.
Open the front cover of the finisher.
Chapter 9 - Paper, toner, and staples
312
Replace the staple cartridge in the saddle stitch unit