Netgear M6100 – Campus Edge and SMB Core Chassis Switches Software Guide
Stacking Commands
44
M5300, M6100, and M7100 Series ProSAFE Managed Switches
Dedicated Port Stacking Commands
This section describes the commands you use to configure dedicated port stacking.
stack
Use this command to set the mode to Stack Global Config.
member (Stack Global Config)
Use this command to add a switch to a stack. The unit is the switch identifier of the switch to
be added to the stack. The switchindex is the index into the database of the supported
switch types, indicating the type of the switch being preconfigured. The switchindex is a
32-bit integer. You issue this command on the Primary Management Unit.
be added to the stack. The switchindex is the index into the database of the supported
switch types, indicating the type of the switch being preconfigured. The switchindex is a
32-bit integer. You issue this command on the Primary Management Unit.
Note:
You can obtain the switch index by issuing the show supported
switchtype
switchtype
command in User EXEC mode.
no member
Use this command to remove a switch from a stack. The unit is the switch identifier of the
switch to be removed from the stack. You issue this command on the Primary Management
Unit.
switch to be removed from the stack. You issue this command on the Primary Management
Unit.
switch priority
Use this command to configure the ability of a switch to become the Primary Management
Unit. The unit is the switch identifier. The value is the preference parameter that lets you
specify the priority of one backup switch over another. The range for priority is 1 to 15. The
switch with the highest priority value becomes the Primary Management Unit if the active
Primary Management Unit fails. The switch priority defaults to the hardware management
Unit. The unit is the switch identifier. The value is the preference parameter that lets you
specify the priority of one backup switch over another. The range for priority is 1 to 15. The
switch with the highest priority value becomes the Primary Management Unit if the active
Primary Management Unit fails. The switch priority defaults to the hardware management
Default
None
Format
stack
Mode
Global Config
Default
None
Format
member unit switchindex
Mode
Stack Global Config
Format
no member unit
Mode
Stack Global Config