Netgear M6100 – Campus Edge and SMB Core Chassis Switches User Guide

None

 

—

  The source address of the ping packet would be the address of the default 

outgoing interface.

IPv6 Address

 

—

  The source IPv6 address to use when sending the Echo request 

packets. This field is shown when IPv6 Address is selected as the source option.

Interface

 

—

  The interface to use when sending the Echo request packets. This field is 

shown when Interface is selected as the source option.

Values configured in the fields above are not saved to the switch. As a 
result, refreshing the page sets these fields to the default values.

Click Apply to send the ping to the specified IPv6 address or hostname. The switch sends 

the number of pings specified in the Count field, and the results are displayed below the 

configurable data in the Results area. 

Click Cancel to cancel the configuration on the screen and reset the data on the screen to 

the latest value of the switch.

Use this screen to tell the switch to send a Traceroute request to a specified IP address or 
Hostname. You can use this to discover the paths packets take to a remote destination. Once 
you click the Apply button, the switch will send traceroute and the results will be displayed 
below the configurable data. 

If a reply to the traceroute is received, you will see:

1 e.f.g.h 9869 usec 9775 usec 10584 usec

2 0.0.0.0 0 usec * 0 usec * 0 usec *

3 0.0.0.0 0 usec * 0 usec * 0 usec *

Hop Count = j Last TTL = k Test attempt = m Test Success = n. 

To display the Traceroute IPv4 page, click Maintenance 





.