Netgear M5300-52G3 (GSM7352Sv2h2) - ProSAFE 48 ports managed L3 gigabit stackable switch Software Guide

Select Switching > MLAG > Advanced > VPC Interface Configuration. 

From the LAG Interface list, select the ID of the local port channel to configure as a VPC 

interface.

Enter a VPC interface identifier value in the VPC Identifier field. 

The possible range is 1 to 63. To form a VPC interface with a port channel on the peer 
device, the port channel on the peer device must use the same VPC identifier.

Click the Add button.

The interface configuration is added.

To delete the selected interface configuration, click the Delete button.

Click the Apply button.

The switch is updated with the values you entered. Configuration changes take effect 
immediately.

The following table describes the nonconfigurable VPC Interface Configuration fields.

State

The VPC interface’s operational mode, which is one of the following:

. VPC functionality is operationally disabled on the VPC 

interface.

. The port channel is waiting for VPC functionality to be 

enabled on a port channel on the peer device.

. VPC functionality is enabled on a port channel on both peer 

devices, but not all entry criteria are met for the port channel to be 
operational. For example, if the combined number of member ports 
for the VPC interface is more than the maximum allowed, then the 
state is set to Error on both devices.

. VPC functionality is enabled on a port channel on both 

peer devices, and all entry criteria are satisfied. The VPC interface 
is operationally enabled, and traffic is allowed to flow through the 
VPC member ports.

. The links connected to the VPC member ports are down, 

but the VPC interface on the peer remains active.