Netgear M5300-52G3 (GSM7352Sv2h2) - ProSAFE 48 ports managed L3 gigabit stackable switch Software Guide
Configure Switching Information
305
M6100, M5300, and M7100 Series Managed Switches
The following table describes the nonconfigurable VPC details that are displayed.
View Virtual Port Channel Interface Details
To configure virtual port channel interface details:
1.
Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
2.
Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.
3.
Launch a web browser.
4.
Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
Table 116. VPC Interface Details
Field
Description
Status
The status of the VPC identifier.
State
The VPC interface’s operational mode, which is one of the following:
•
Disabled
. VPC functionality is operationally disabled on the VPC
interface.
•
Wait
. The port channel is waiting for VPC functionality to be
enabled on a port channel on the peer device.
•
Error
. VPC functionality is enabled on a port channel on both peer
devices, but not all entry criteria are met for the port channel to be
operational. For example, if the combined number of member ports
for the VPC interface is more than the maximum allowed, then the
state is set to Error on both devices.
operational. For example, if the combined number of member ports
for the VPC interface is more than the maximum allowed, then the
state is set to Error on both devices.
•
Active
. VPC functionality is enabled on a port channel on both
peer devices, and all entry criteria are satisfied. The VPC interface
is operationally enabled, and traffic is allowed to flow through the
VPC member ports.
is operationally enabled, and traffic is allowed to flow through the
VPC member ports.
•
Inactive
. The links connected to the VPC member ports are down,
but the VPC interface on the peer remains active.
VPC Identifier
The VPC interface identifier value. The range is 1 to 63.
Configured VLANs
The VLAN ID or list of VLAN IDs in which the LAG is a member.
Note:
If the VLAN Member or the VLAN Tag field exceeds the
maximum number of displayable VLANs, an Exceeded data limit to
display
display
message is shown. Editing the values of these fields is
prevented when at least one port reaches the maximum limit of VLANs
during port multiselection.
during port multiselection.
Egress Tagging
The VLAN ID or list of VLAN IDs on which the LAG is tagged.
Peer Link STP Mode
The Spanning Tree Protocol administrative mode associated with the
LAG.
LAG.