Netgear M5300-28G3 (GSM7328Sv2h2) - ProSAFE 24+4 Gigabit Ethernet L3 Managed Stackable Switch Software Guide

Use this command to set the number of listener-specific queries sent before the router 
assumes that there are no local members on an interface or range of interfaces. The range 
for the number argument is 1 to 20.

Use this command to reset the last-member-query-count

of the interface to the default 

value.

Use this command to configure the MLD version that the interface uses.

This command resets the MLD version used by the interface to the default value.

Use this command to display information about multicast groups that MLD reported. The 
information is displayed only when MLD is enabled on at least one interface. If MLD was not 
enabled on even one interface, there is no group information to be displayed. 

The argument unit/slot/port corresponds to a physical routing interface or VLAN 
routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN 
ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id parameter 
is a number in the range of 1–4093. You can also specify a group address 
(group-address).

Default

2

Format

ipv6 mld last-member-query-count number

Mode

Interface Config

Format

no ipv6 mld last-member-query-count

Mode

Interface Config

Default

2

Format

ipv6 mld version {1 | 2}

Mode

Interface Config

Format

no ipv6 mld

Mode

Interface Config