Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Software Guide
Configure Quality of Service
516
M6100, M5300, and M7100 Series Managed Switches
7.
Select QoS > CoS> Advanced > CoS Interface Configuration.
8.
Select LAG to show the list of all LAG interfaces.
9.
Select All to show the list of all physical as well as LAG interfaces.
10.
Select an interface from the Interface list of all CoS configurable interfaces.
11.
Use the Go To Interface field to enter the interface in unit/slot/port format and click the Go
button.
The entry corresponding the specified interface is selected.
12.
Use Interface Trust Mode to specify whether or not to trust a particular packet marking at
ingress.
Interface Trust Mode can be one of the following:
•
Untrusted
•
802.1p
•
IP DSCP
The default value is 802.1p.
13.
Use Interface Shaping Rate to specify the maximum bandwidth allowed.
This is typically used to shape the outbound transmission rate.This value is controlled
independently of any per-queue maximum bandwidth configuration. It is effectively a
second-level shaping mechanism. The default value is 0. Valid Range is 0 to 100 in
increments of 1. The value 0 means that the maximum is unlimited.
independently of any per-queue maximum bandwidth configuration. It is effectively a
second-level shaping mechanism. The default value is 0. Valid Range is 0 to 100 in
increments of 1. The value 0 means that the maximum is unlimited.
14.
Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
immediately.