Netgear M4300-28G-PoE+ (GSM4328PB) - 24x1G PoE+ Stackable Managed Switch with 2x10GBASE-T and 2xSFP+ (1000W PSU) Software Guide
Switching Commands
423
M4200 and M4300 Series ProSAFE Managed Switches
no mode dvlan-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By
default, Double VLAN Tunneling is disabled.
default, Double VLAN Tunneling is disabled.
show dot1q-tunnel
Use this command without the optional parameters to display all interfaces enabled for
Double VLAN Tunneling. Use the optional parameters to display detailed information about
Double VLAN Tunneling for the specified interface or all interfaces.
Double VLAN Tunneling. Use the optional parameters to display detailed information about
Double VLAN Tunneling for the specified interface or all interfaces.
show dvlan-tunnel
Use this command without the optional parameters to display all interfaces enabled for
Double VLAN Tunneling. Use the optional parameters to display detailed information about
Double VLAN Tunneling for the specified interface or all interfaces.
Double VLAN Tunneling. Use the optional parameters to display detailed information about
Double VLAN Tunneling for the specified interface or all interfaces.
Default
disabled
Format
mode dvlan-tunnel
Mode
Interface Config
Format
no mode dvlan-tunnel
Mode
Interface Config
Format
show dot1q-tunnel [interface {unit/slot/port | all}]
Mode
Privileged EXEC
User EXEC
Term
Definition
Interface
The interface.
Mode
The administrative mode through which Double VLAN Tunneling can be enabled or disabled. The
default value for this field is disabled.
default value for this field is disabled.
EtherType
A 2-byte hex EtherType to be used as the first 16 bits of the DVLAN tunnel. There are three different
EtherType tags. The first is 802.1Q, which represents the commonly used value of 0x8100. The
second is vMAN, which represents the commonly used value of 0x88A8. If EtherType is not one of
these two values, then it is a custom tunnel value, representing any value in the range of 1 to 65535.
second is vMAN, which represents the commonly used value of 0x88A8. If EtherType is not one of
these two values, then it is a custom tunnel value, representing any value in the range of 1 to 65535.
Format
show dvlan-tunnel [interface {unit/slot/port | all | lag lag-intf-num}]
Mode
Privileged EXEC
User EXEC