Netgear M4100-D12G-POE+ (GSM5212P) - ProSAFE Gigabit L2+ Managed Switch Software Guide

This section describes the commands you use to configure and view Class of Service (CoS) 
settings for the switch. The commands in this section allow you to control the priority and 
transmission rate of traffic. 

Commands you issue in the Interface Config mode only affect a single 
interface. Commands you issue in the Global Config mode affect all 
interfaces.

This command maps an 802.1p priority to an internal traffic class. The <userpriority> 
values can range from 0-7. The <trafficclass> values range from 0-6, although the 
actual number of available traffic classes depends on the platform. For more information 
about 802.1p priority, see 

Global Config

Interface Config

 This command maps each 802.1p priority to its default internal traffic class value. 

Global Config

Interface Config

 

This command maps an IP DSCP value to an internal traffic class. The <ipdscp> value is 
specified as either an integer from 0 to 63, or symbolically through one of the following 
keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, be, cs0, cs1, 
cs2, cs3, cs4, cs5, cs6, cs7, ef.

The <trafficclass> values can range from 0-6, although the actual number of available 
traffic classes depends on the platform.

Format

classofservice dot1p-mapping <userpriority> <trafficclass>

Modes

Format

no classofservice dot1p-mapping

Modes

Format

classofservice ip-dscp-mapping <ipdscp> <trafficclass>

Modes

Global Config