Zanussi ZBF22451SA User Manual
heating. To achieve sufficient ventilation fol-
low the instructions relevant to installation.
low the instructions relevant to installation.
• Wherever possible the back of the product
should be against a wall to avoid touching
or catching warm parts (compressor, con-
denser) to prevent possible burn.
or catching warm parts (compressor, con-
denser) to prevent possible burn.
• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessible
after the installation of the appliance.
• Connect to potable water supply only (If a
water connection is foreseen).
Service
• Any electrical work required to do the serv-
icing of the appliance should be carried out
by a qualified electrician or competent per-
son.
by a qualified electrician or competent per-
son.
• This product must be serviced by an author-
ized Service Centre, and only genuine spare
parts must be used.
parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in
which could damage the ozone layer, in
either its refrigerant circuit or insulation materi-
als. The appliance shall not be discarded to-
gether with the urban refuse and rubbish. The
insulation foam contains flammable gases: the
appliance shall be disposed according to the
applicable regulations to obtain from your local
authorities. Avoid damaging the cooling unit,
especially at the rear near the heat exchanger.
The materials used on this appliance marked
by the symbol
als. The appliance shall not be discarded to-
gether with the urban refuse and rubbish. The
insulation foam contains flammable gases: the
appliance shall be disposed according to the
applicable regulations to obtain from your local
authorities. Avoid damaging the cooling unit,
especially at the rear near the heat exchanger.
The materials used on this appliance marked
by the symbol
are recyclable.
Control panel
5
6
4
3
2
1
1
Display
2
Temperature warmer button
3
Temperature colder button
4
OK button
5
Mode button
6
ON/OFF button
Display
Off
1
3
2
4
5
6
1
Freezer OFF indicator
2
Fast Freeze function
3
Freezer temperature indicator
4
Freezer compartment indicator
5
Alarm indicator
6
Child Lock function
Switching on
To switch on the appliance do these steps:
1.
Connect the mains plug to the power
socket.
socket.
2.
Press the ON/OFF button if the display is
off.
off.
3.
The alarm buzzer may sound after a few
seconds.
To reset the alarm refer to "Door open
alarm".
If “DEMO” appears on the Display, the ap-
pliance is in demonstration mode: refer to
“Troubleshooting” paragraph.
seconds.
To reset the alarm refer to "Door open
alarm".
If “DEMO” appears on the Display, the ap-
pliance is in demonstration mode: refer to
“Troubleshooting” paragraph.
4.
The temperature indicators show the set
default temperature.
default temperature.
4
www.zanussi.com