Zanussi ZRB33100WA User Manual

Temperature is set incorrectly.

Refer to "Operation" chapter.

Water flows on the rear plate of

the refrigerator.

During the automatic defrost-

ing process, frost melts on the

rear plate.

This is correct.

Water flows inside the refrigera-

tor.

The water outlet is clogged.

Clean the water outlet.

Food products prevent that

water flows into the water col-

lector.

Make sure that food products do

not touch the rear plate.

Water flows on the floor.

The melting water outlet is not

connected to the evaporative

tray above the compressor.

Attach the melting water outlet to

the evaporative tray.

The temperature in the appliance

is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower temperature.

The door is not closed correct-

ly.

Refer to "Closing the door".

The food products' tempera-

ture is too high.

Let the food products temperature

decrease to room temperature be-

fore storage.

Many food products are stored

at the same time.

Store less food products at the

same time.

The thickness of the frost is

greater than 4-5 mm.

Defrost the appliance.

The door has been opened of-

ten.

Open the door only if necessary.

There is no cold air circulation

in the appliance.

Make sure that there is cold air cir-

culation in the appliance.

If the advice does not lead to the

desired result, call the nearest

brand-mark service.

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door

gaskets. Contact the After Sales Service.

The appliance is equipped with a

longlife LED interior light.

Disconnect the plug from the mains

socket.

1. At the same time, with the fingers expand

up and down the transparent cover and

unhook it in the direction of the arrows.