Zanussi ZBB28651SA User Manual

The compressor does not start

immediately after pressing the

QuickFreeze, or after changing

the temperature.

This is normal, no error has

occurred.

The compressor starts after a pe-

riod of time.

Water flows inside the refriger-

ator.

The water outlet is clogged.

Clean the water outlet.

Food products prevent that

water flows into the water

collector.

Make sure that food products do

not touch the rear plate.

Water flows on the floor.

The melting water outlet is

not connected to the evapo-

rative tray above the com-

pressor.

Attach the melting water outlet to

the evaporative tray.

The temperature in the appli-

ance is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower temperature.

The door is not closed cor-

rectly.

Refer to "Closing the door".

The food products' tempera-

ture is too high.

Let the food products tempera-

ture decrease to room tempera-

ture before storage.

Many food products are stor-

ed at the same time.

Store less food products at the

same time.

The door has been opened

often.

Open the door only if necessary.

There is no cold air circula-

tion in the appliance.

Make sure that there is cold air

circulation in the appliance.

If the advice does not lead to the

desired result, contact the nearest

Authorised Service Centre.

REPLACING THE LAMP
The appliance is equipped with a longlife LED

interior light.
Only service is allowed to replace the lighting

device. Contact your Authorised Service Centre.

CLOSING THE DOOR
1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to assembly

instructions.

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

WARNING! Refer to Safety chapters.

Refer to the assembly instructions for

the installation.