Philips BT 1005 Beardtrimmer series 1000 User Manual

ENGLISH

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benefit from the support that Philips

offers, register your product at www.philips.com/

welcome.

Important safety information

Read this important information carefully before

you use the appliance and its accessories and save

it for future reference. The accessories supplied

may vary for different products.

Warning

- This appliance can be used by children aged

from 8 years and above and persons with

reduced physical, sensory or mental capabilities

or lack of experience and knowledge if they

have been given supervision or instruction

concerning use of the appliance in a safe way

and understand the hazards involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be

made by children without supervision.

- Always check the appliance before you use

it. Do not use the appliance if it is damaged,

as this may cause injury. Always replace a

damaged part with one of the original type.
Caution

- This appliance is not washable.

Never immerse the appliance in water and do

not rinse it under the tap (Fig. 1).

- Only use this appliance for its intended

purpose as shown in the user manual.

- For hygienic reasons, the appliance should only

be used by one person.

- Never use compressed air, scouring pads,

abrasive cleaning agents or aggressive liquids

such as petrol or acetone to clean the appliance.

- Only operate the appliance on 1.5V LR6 AA

batteries.

- Use and store the appliance at a temperature

between 15°C and 35°C.

- Do not expose the appliance to direct sunlight.

- Remove batteries from the appliance if you are

not going to use it for some time.
Electromagnetic fields (EMF)

- This Philips appliance complies with all

applicable standards and regulations regarding

exposure to electromagnetic fields.
General

- Maximum noise level: Lc = 75dB(A)

Preparing for use
Placing the batteries

Open the battery holder and put the

batteries into the battery holder. (Fig. 2)

Make sure your hands are dry when inserting the

batteries.

Make sure the + and - poles of the batteries point

in the right direction.

Close the battery holder.

Using the appliance

When you trim for the first time, be careful and

test the appliance on a small part of your arm

or leg. Do not move the trimmer too fast, make

smooth and gentle movements.

Trimming with comb

Slide the comb to the desired hair length

(Fig. 3).

The hair length in millimeters appears in the

window in the centre of the comb.
Note: When you trim for the first time, start at the

highest length setting to familiarise yourself with the

appliance.

Switch on the appliance.

Place the trimmer on the skin.

Move the trimmer slowly over the skin

against the direction of the hair growth while

pressing it lightly (Fig. 4).

Make sure the flat surface of the comb always stays

in contact with the skin.

If a lot of hair has accumulated in the

comb:

Make sure the appliance is switched off.

Slide the comb to the highest setting and pull

it off the appliance (Fig. 5).

Never pull off the comb at the flexible top part,

always pull it off at the bottom part.

Blow and/or shake the hairs out of the comb

(Fig. 6).
Trimming without comb

Use the trimmer without comb to trim full bears

and single hairs.
Note: The comb keeps the cutting unit at a certain

distance from the skin. If you use the trimmer without

comb, the hair will be cut off at the point where the

cutting unit touches the hair.

4222.002.8632.1

BT1005, BT1000

www.philips.com/welcome

1,5

1 5