Bosch TDS-2241 Sensixx B 22 L User Manual

19

BOSCH

* Model dependent

Pilot light (12*) will flash indicating that boiler 

must be rinsed. 
1 

Check carefully that the appliance is cold and 

unplugged for more than 2 hours, and that the 

water tank (1) is empty.

2 

Model dependent: Fix the iron to the stand 

by inserting the tip of the iron into the front slot 

and moving the fixation lever (14*) against the 

heel of the iron.

3 

Place your appliance over a sink or bucket. 

4 

Lean the appliance on the opposite side of the 

filter opening.

5 

Unscrew the filter (4*) and take it out.

6 

Model dependent: To wash the scale collector, 

place it under the water tap and wash it up until calc 

residues are removed. Squeeze it as indicated in the 

picture a).

  To obtain the best result, you may immerse the scale 

collector for approximately 30 minutes in tap water 

(250 ml) mixed with a measure (25 ml) of descaling 

fluid, as indicated in the picture b). Then, rinse it 

again with water (very important!).

  The descaling fluid can be obtained from our 

After-sales service or from our website.

Accessory code 

(After-sales)

Name of accessory 

(Online shop)

00311715

TDZ1101

7 

Holding your steam generator in the lateral 

position and using a jug, fill the boiler with 1/4 

litre of water and replace the filter.

8 

Shake the base unit for a few moments, 

unscrew the filter again and empty the boiler 

completely over a sink or bucket. 

  For best results, we recommend that this 

operation is performed twice.

  Important: before re-closing, make sure no 

water remains in the boiler.

9 

Replace and tighten up the filter.

If during ironing, the steam release button 

(17-18*) on the iron handle is not pressed for a 

certain length of time (8 minutes), the steam 

station will automatically switch off. 

The “auto shut-off” pilot lamp (9) will flash when 

auto shut-off has been activated. 

To switch the steam station back on, press the 

steam release button again.

TextileProtect



 

The fabric-protection soleplate cover (21*) is 

used for steam-ironing delicate garments at 

maximum temperature without damaging them. 

Use of the soleplate cover also does away with 

the need for a cloth to prevent shine on dark 

materials.

It is advisable to first iron a small section on the 

inside of the garment to see if it is suitable.

To attach the soleplate cover to the iron, place 

the tip of the iron into the end of the soleplate 

cover and pull the elastic strap over the lower 

rear of the iron until it fits tightly. To release the 

soleplate cover, pull the elastic strap and remove 

the iron.

The fabric-protection soleplate cover may be 

purchased from our customer service or from our 

website.

Accessory code  

(After-sales)

Name of accessory 

(Online shop)

00571510

TDZ2045



 

To extend the life of your steam generator and to 

prevent any build up of scale, it is essential that 

you rinse out the filter (4*) and the boiler after 

several hours of use. If the water is hard, 

increase the frequency.

Do not use descaling agents for rinsing out the 

boiler, as they could damage it.