APC MASTERSWITCH POWER RECEPTACLE BAYING TRAY AP9510BAY User Manual

3

continued

2. Using a Phillips head screwdriver, remove the 

four outermost

 6-32

 screws from the front panel of each 

Power Receptacle to be mounted in the tray, as shown in 
the figure below.    

3. Remove blanking panels from the front of the Power 

Receptacle Tray, as necessary.

4. Insert each Power Receptacle unit into one of the bays 

of the tray, aligning the holes on front panel of the unit 
with the holes in the flanges of the tray. Attach with the 
four 

6-32

 screws removed in Step 2. 

5. Attach a blanking panel to any empty bays, using four 

6-

32

 screws (provided). See the figure on page 4  for an 

example setup.

6. Place the mounting brackets on the side of the tray, 

inserting the two tray studs into the slit of each bracket. 
Slide the brackets forward to allow room for the power 
cords that will be connected at the rear of the rack. 
Attach using two 

8-32

 acorn nuts (provided with the 

Power Receptacle Tray) for each bracket.

Remove Screws