Cisco Cisco Prime Optical 10.6 Developer's Guide

Cisco Prime Optical 10.6 GateWay/CORBA Programmer Reference Guide 

 

 

619

 

  The /opt/CiscoTransportManagerServer/openfusion/bin directory contains nsMgrTool, dior, and 

server utility tools. 

 

You can configure the following GateWay/CORBA properties in the Prime Optical client Control Panel. 

Step 1 

From the Domain Explorer, choose Administration > Control Panel. 

Step 2 

In the Control Panel, click GateWay/CORBA Service. Configure the following properties: 

  If GateWay/CORBA is running, changes to the config file do not take effect 

dynamically. You must restart GateWay/CORBA for the changes to take effect. 

  Enable Encryption for username and password: 

  This property defines whether to encrypt the username and password used for the 

GateWay/CORBA client.  

  Heartbeat for Notification Channel (min): 0  
  This property is the rate at which the notification service is checked. A zero entry 

means not to check the notification service.  

  Enter the maximum number of simultaneous sessions: 4 

  This property is the number of GateWay/CORBA sessions that can be active at 

the same time. The range is from 4 to 25 sessions. 

  Enter the maximum events per consumer: 10000 

  GateWay/CORBA uses this property to set the MaxEventsPerConsumer 

administrative QoS parameter of the notification channel. The notification server 
uses this property to bound the maximum number of events in a given channel 
that are allowed to queue at any given time. The default value is 0, where the 
notification server does not impose a limit on the maximum number of events that 
can be queued. If no limits are imposed on the queue, the notification server might 
run out of memory if a client behaves incorrectly. The server must keep all events 
in memory until they are consumed by all registered consumers. 

 Any change to this value should be made with extreme caution. If you set the value 

too low, the NMS will not receive all notifications. If you set the value too high, the 
Prime Optical notification server will run out of memory. The current value is set to 
handle alarm bursts of 10,000 events per minute. 

  Enter the notification service name: NotificationService 

This property defines the service name that the resolve_initial_reference function uses to 
get a reference to the notification service. The GateWay/CORBA installation installs the 
notification service automatically. To use your own notification service, modify this 
parameter.  

You do not need to change this parameter if you plan to use the notification service 
that is bundled with GateWay/CORBA. 

 

  Enter the notification service naming context: services/NotifyChannelFactory