eutech-instruments cyberscan ph 110 phmvrs232 meter User Manual

Instruction Manual   

 

CyberScan pH 11 / 110  

 

23

The pH 110 meter is equipped with an RS232 communication port and a PRINT (

) 

key that facilitate the printing of data from the meter to a printer or computer.  

1.  To use the pH 110 directly with a printer, the printer should have either a 9 

pin or a 25 pin RS 232C serial port. 

2.  Communication settings of the printer or computer’s data acquisition software 

(CyberComm Portable DAS) MUST match the following parameters:  

a. Baud Rate:  9600 

b. Parity Bit:  None 

c. Stop Bit: 

One 

d. Data Bit: 

8 

e. Flow Control: None 

3.  Please refer to your printer’s or computer’s instruction manual for more 

information on its communication setup protocol. 

4.  Use 9-pin cable (Refer to section 15 - LIST OF ACCESSORIES on page 65) 

to connect the meter to the printer. If the printer has a 25 pin connector, use 
the 9 to 25 pin cable or make your own cable taking note of the connection 
parameters as described in section 3.4 - Connecting the RS232C Cable 
(Only for pH 110) on page 9.  

5.  Turn on pH 110 meter and note the following: 

f.  For printer, ensure it is powered on and paper is loaded.  

g.  For computer, ensure that Eutech Instruments’ CyberComm Portable 

Data Acquisition Software is installed and activated. See section 10.3 - 
Running CyberComm Portable on page 51.  

6.  To send data to the printer or computer, press the PRINT key. 

When the PRINT key is pressed, there are two options:  

•  dAt / CUr: Print Data on Timed Interval basis. You can print any data 

automatically based a pre-set timing from 5 to 30 seconds.