Apple xserve Service Manual
Xserve Take Apart - 55
Light Pipe, Xserve
Procedure
1.
Release the two clips on the sides of the front panel board, and pull the board back
approximately 1.5 inches from the front of the server.
2.
Remove the light pipe from the server.
Replacement Note: When repositioning the light pipe against the inside front of the bezel,
make sure the projections on the light pipe fit into the holes in the bezel. Then slide the
panel board forward until it fits against the light pipe. Note: You may need to lift the light
pipe slightly while sliding the front panel board, so that it doesn’t catch the edge of the light
pipe.