Audiovox 50-0301x-014 series User Manual

                                                                                                3

   I. PREPARATION OF VEHICLE INTERIOR 

 

 
 
 
 
 
 

1.  Retract storage cover, remove from location 

and lay it in a safe place. See Figure 1. 

2.  Fold rear seat forward.  

 
 
 
 
 

 

 

3.   Install and route all video and audio cables, and 

any other added component requirements to their 
respective places in the vehicle. Refer to 
component installation instructions for wiring 
diagrams. The suggested routing of the video 
system cable is as follows: Above the headliner 
from video system to C-pillar. Down the C-pillar to 
the floor. Route the power lead to a fused 
accessory controlled source. Connect the ground 
lead to the vehicle chassis. Route the remaining 
wiring (RCA plugs, Remote Sensor extension, etc.) 
to the VCP location. See Figure 2. Connect per 
instructions included with the video system. If 
video system if to be used as a television,  install an 
appropriate antenna  per instructions included with 
the antenna.                                                    

 

II. INSTALLATION OF HOUSING 

 

         
4.  Remove and retain (2) two # 8 X 9/16" screws (item 1 

pg 2 ) from VCP housing assembly. Separate VCP 
housing (item 4 pg 2) from mounting bracket (item 3 
pg 2). Install mounting bracket as shown in Fig. 3.   
Secure using (8) eight # 8 X 9/16" screws (item 1    
pg 2).   

 

 

 

 

FIGURE 1 

FIGURE 2 

FIGURE 3