Audiovox 50-0312x series User Manual

                                                                                                3

   I. PREPARATION OF VEHICLE INTERIOR 

 

 
 

1.  Remove and retain (3) three screws which 

secure rear driver’s side seat track in place. 

2.  Slide rear seat forward and remove and retain 

seat track. See Figure 1. 

3.  Mark wire location as shown in Figure1 and 

drill a 1" hole in plastic panel. Caution: Before 
drilling, check for wiring or other 
componentry behind panel. Drill only where 
indicated.  

 
 
 

 

 

4.   Install and route all video and audio cables, and 

any other added component requirements to their 
respective places in the vehicle. Refer to 
component installation instructions for wiring 
diagrams. The suggested routing of the video 
system cable is as follows: Above the headliner 
from video system to C-pillar. Down the C-pillar 
to the floor. Route the power lead to a fused 
accessory controlled source. Connect the ground 
lead to the vehicle chassis. Route the remaining 
wiring (RCA plugs, Remote Sensor extension, 
etc.) to the VCP location. See Figure 2. Connect 
per instructions included with the video system. 
If video system if to be used as a television,  
install an appropriate antenna  per instructions 
included with the antenna.                                                    

 

II. INSTALLATION OF HOUSING 

 

 
 

5.  Make (3) three cuts and fold carpet as shown in Figure 3.   

 

 

 

 

FIGURE 1 

FIGURE 2 

FIGURE 3