3com 900-0387-01 User Manual

 

 V6000 Analog Integrated Branch Office Solution Installation Guide V6000 Analog Integrated Branch Office Sol

18 

2  Use a standard Telnet application to connect to the V6000 Embedded Telnet Server. 

3  Login using the username (‘Admin’) and password (‘Admin’). 

To access the CLI via the RS-232 port, follow these 2 steps: 

1  Connect the V6000 RS-232 port (labeled I0I0), located on the CPU module of the V6000 

front panel, to either COM1 or COM2 RS-232 communication port on your PC with the 
supplied RS-232 cable. 

2  Use serial communication software (e.g., HyperTerminal

TM

) to connect to the  

V6000.  
Set your serial communication software to the following communications port settings: 

ƒ  Baud Rate: 

115,200 bps 

ƒ Data 

bits: 

8 

ƒ Parity: 

 

None 

ƒ Stop 

bits: 

1 

ƒ Flow 

control: Hardware 

The CLI prompt is available immediately. 

To assign an IP address via the CLI, follow these 4 steps: 

1  At the prompt type ‘conf’ and press enter; the configuration folder is accessed. 

2  To check the current network parameters, at the prompt, type ‘GCP IP’ and press enter; 

the current network settings are displayed. 

3  Change the network settings by typing: ‘SCP IP [ip_address] [subnet_mask] 

[default_gateway]’ (e.g., ‘SCP IP 10.13.77.7 255.255.0.0 10.13.0.1’); the new settings 
take effect on-the-fly. Connectivity is active at the new IP address. 

 

4  To save the configuration, at the prompt, type ‘SAR’ and press enter; the V6000 restarts 

with the new network settings.