Sony HTDDW670 User Manual
Amplifier Operation
masterpage:Right
lename[E:\SEM_Janet\Revision_DDW670\J904000_2342216121DDW670_GB\2342216121\G
B04BSC_HT-DDW670-U.fm]
19
GB
model name1[HT-DDW670]
[2-342-216-12(1)]
You can listen to FM and AM broadcasts
through the built-in tuner. Before operation,
make sure you have connected the FM and AM
antennas to the receiver (see page 10).
through the built-in tuner. Before operation,
make sure you have connected the FM and AM
antennas to the receiver (see page 10).
Tip
The tuning scale differs depending on the area code as
shown in the following table. For details on area codes,
see page 3.
shown in the following table. For details on area codes,
see page 3.
Automatic tuning
If you do not know the frequency of the station
you want, you can let the receiver scan all
available stations in your area.
you want, you can let the receiver scan all
available stations in your area.
1
Press FM or AM to select the FM or AM
band.
band.
The last received station is tuned in.
2
Press TUNING + or TUNING –.
Press TUNING + to scan from low to high;
press TUNING – to scan from high to low.
The receiver stops scanning whenever a
station is received.
press TUNING – to scan from high to low.
The receiver stops scanning whenever a
station is received.
Tip
If “STEREO” flashes in the display and the FM stereo
reception is poor, press FM MODE to change to
monaural (MONO). You will not be able to enjoy the
stereo effect, but the sound will be less distorted. To
return to stereo mode, press FM MODE again.
reception is poor, press FM MODE to change to
monaural (MONO). You will not be able to enjoy the
stereo effect, but the sound will be less distorted. To
return to stereo mode, press FM MODE again.
Direct tuning
You can enter the frequency of the station you
want directly. Use the remote for the operation.
want directly. Use the remote for the operation.
1
Press TUNER repeatedly to select the
FM or AM band.
FM or AM band.
The last received station is tuned in.
Tip
You can also use FM or AM on the receiver.
2
Press D.TUNING.
3
Press the numeric buttons to enter the
frequency.
frequency.
Example 1: FM 102.50 MHz
Press 1
Press 1
b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Press 1
Press 1
b 3 b 5 b 0
(You do not have to enter the last “0” when
the tuning scale is set to 10 kHz.)
If you have tuned in an AM station, adjust
the direction of the AM loop antenna for
optimum reception.
the tuning scale is set to 10 kHz.)
If you have tuned in an AM station, adjust
the direction of the AM loop antenna for
optimum reception.
If you cannot tune in a station
and the entered numbers flash
and the entered numbers flash
Make sure you have entered the right frequency.
If not, repeat steps 2 and 3. If the entered
numbers still flash, the frequency is not used in
your area.
If not, repeat steps 2 and 3. If the entered
numbers still flash, the frequency is not used in
your area.
Listening to FM/AM radio
Area code
FM
AM
U, CA
100 kHz
10 kHz*
CEL, CEK, SP, AU
50 kHz
9 kHz
MX
50 kHz
10 kHz
E51
50 kHz
10 kHz*
GB01COV_HT-DDW670-U.book Page 19 Saturday, January 1, 2005 7:54 AM