Sony HTSF2300 User Manual
28
GB
Tips
• When Auto Calibration starts:
– Stand some distance from the speakers and the
listening position to avoid measurement failure.
This is because test signals are output from the
speakers during measurement.
This is because test signals are output from the
speakers during measurement.
– Avoid making noise to get a more accurate
measurement.
• The Auto Calibration function will be canceled
when you do the following during the
measurement process:
measurement process:
– Press ?/1 or MUTING.
– Press input buttons on the remote or INPUT
– Press input buttons on the remote or INPUT
SELECTOR on the receiver.
– Change the volume level.
– Press AUTO CAL again.
– Press AUTO CAL again.
1
Confirm the measurement
result.
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
sounds and the measurement result
appears on the display.
2
Press
V/v repeatedly to select
the item. Then, press
.
3
Save the measurement result.
Select “SAVE” in step 2.
The measurement results are saved.
The measurement results are saved.
When error codes appear
Try the remedies and perform the Auto
Calibration again.
Calibration again.
Confirming/saving the
measurement results
measurement results
Measurement
result
result
Display
Explanation
When the
measurement
process
completes
properly
measurement
process
completes
properly
SAVE
Proceed to step
2.
2.
When the
measurement
process fails
measurement
process fails
ERROR
XXXX
XXXX
Item
Explanation
RETRY
Performs the Auto
Calibration again.
Calibration again.
SAVE Saves
the
measurement
results and exits the setting
process.
process.
WARN CHK
PHASE
Displays the phase of each
speaker (in phase/out of
phase). See “When you
select “PHASE”” (page 29).
speaker (in phase/out of
phase). See “When you
select “PHASE”” (page 29).
DISTANCE
Displays the measurement
result for speaker distance.
result for speaker distance.
LEVEL
Displays the measurement
result for speaker level.
result for speaker level.
EXIT
Exits the setting process
without saving the
measurement results.
without saving the
measurement results.
Error code
Cause and remedies
ERROR 32
None of the speakers were
detected. Make sure that the
optimizer microphone is
connected properly and perform
the Auto Calibration again.
If the optimizer microphone is
connected properly but the error
code appears, the optimizer
microphone cable may be
damaged or improperly connected.
detected. Make sure that the
optimizer microphone is
connected properly and perform
the Auto Calibration again.
If the optimizer microphone is
connected properly but the error
code appears, the optimizer
microphone cable may be
damaged or improperly connected.
ERROR F 33
• None of the front speakers are
connected or only one front
speaker is connected.
speaker is connected.
• The optimizer microphone is not
connected.