Elite Screens TE135HC2 User Manual
2
Warning
Red 1 2V (+)
Green 0V (-)
5-12 volt trigger adaptor cable
IR ”eye” recei ver
2x AAA Batter i e s
IR Remote RF
Remote Wall box switch
Bubble lev eler
Standard accessories for CineTension 2
Control System
The screen’s Top Black Drop is already set to its maximum drop distance. There is NO extra black drop in
the roller. Please be aware of this as it will void the limitation of your warranty.
Changes or modifications (except cutting the power cord for hardwire installation) to this product not
expressly approved by Elite Screens is prohibited and will void the warranty.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
9
Reorient or relocate the receiving antenna of the device which may be causing interference
9
Increase the separation between the screen and the device’s receiver
9
Connect the equipment into a different power outlet than the device’s
1. 5/12V Trigger:
The built-in 5
/
12V trigger
input for your new CineTension2 allows your screen
to synchronize its drop and rise with the projector's power
cycle. The screen drops when the projector powers up and
retracts when the projector powers down. The 5/12 volt
adaptor connects to your projectors trigger output via a
separate cable that may or may not be provided by the
projector manufacture. The trigger feature will not work
without an output cable from the projector, but it can be
tested using a 9-volt battery by simply connecting the Red
(+) and Green (-) cable to the 9-volt battery.
to synchronize its drop and rise with the projector's power
cycle. The screen drops when the projector powers up and
retracts when the projector powers down. The 5/12 volt
adaptor connects to your projectors trigger output via a
separate cable that may or may not be provided by the
projector manufacture. The trigger feature will not work
without an output cable from the projector, but it can be
tested using a 9-volt battery by simply connecting the Red
(+) and Green (-) cable to the 9-volt battery.
3-prong power cable
Red: DC 12 +
Green: 0 V -
Green: 0 V -
RJ-45 input connection for
5/12 volt trigger inside of case
5/12 volt trigger inside of case