Denon dvd-5910 ost-f1018 Service Manual

 

 

       

 

 

 

 

. : 

 OST-F1018 

 June 20, 2007 

 

 

DVD-5910   

 

 

 

 

 

Countermeasure for a malfunction on the Analog 2-channel Output-

terminal.

 

 

 

 No sound output from the Analog 2-channel output terminal. (The 

5.1-channel outputs the sound signal properly.) 
 

 
Solution:  

Add a 10k-ohm resistor (P/N 00D 241 2400 995) to Pin #146 of 

IC502 so that it is pulled up to +3.3V which allows the Boot operation to start 
properly. 
MODIFICATION:

 (Upon claim and/or refurbishment of the unit) Apply the 

following modification to the subject models upon customer claim and/or 
refurbishment of the unit. 
• The P. W. Board to which the modification is applied: SYSTEM UNIT 

 

• Modification parts: 

 

 
 
 

The information contained in this document is intended for the exclusive use by DENON Authorized Service Centers and their 
employees.  This document may contain information that is privileged, confidential and may be protected from disclosure under 
applicable laws and terms of the DENON Service Agreement.  Any distribution, disclosure, dissemination or copying of this 
document and the information it contains is prohibited.  No responsibility will be accepted by DENON for any damage, injury or loss 
resulting from the misuse of the information contained in this document.