Denon dvd-5910 ost-f1018 Service Manual
______________________________________________________________________________________
CONFIDENTIALITY NOTICE:
The information contained in this document is intended for the exclusive use by DENON Authorized Service Centers and their
employees. This document may contain information that is privileged, confidential and may be protected from disclosure under
applicable laws and terms of the DENON Service Agreement. Any distribution, disclosure, dissemination or copying of this
document and the information it contains is prohibited. No responsibility will be accepted by DENON for any damage, injury or loss
resulting from the misuse of the information contained in this document.
employees. This document may contain information that is privileged, confidential and may be protected from disclosure under
applicable laws and terms of the DENON Service Agreement. Any distribution, disclosure, dissemination or copying of this
document and the information it contains is prohibited. No responsibility will be accepted by DENON for any damage, injury or loss
resulting from the misuse of the information contained in this document.
1) Solder the 10k-ohm resistor to the + side (+3.3V_D1-1) of the C505. (Insert
the Rubber Sheet under the resistor.)
2) Connect one end of the Vinyl Wire to the Pin #146 of the IC502
(EP1C12Q240C8) and connect the other end of the wire to the lead-wire of the
resistor, as shown on the above.
the Rubber Sheet under the resistor.)
2) Connect one end of the Vinyl Wire to the Pin #146 of the IC502
(EP1C12Q240C8) and connect the other end of the wire to the lead-wire of the
resistor, as shown on the above.
Serial Number Range:
(Last 5-digits)
~ 10001*
* After the above serial number, a new P. W. Board “00D 222 3653 203” will be
installed on the production models.
~ 10001*
* After the above serial number, a new P. W. Board “00D 222 3653 203” will be
installed on the production models.