Siemens gigaset c34 User Manual

Gigaset C34 / ISR eng / A31008-M1607-B501-1-7619 / start_guide_time.fm / 22.3.05

When it has fully dried out you will nor-

mally be able to use it again.

at www.siemens.com/gigasetcustomer-

care. The table below contains a list of 

common problems and possible solutions.

We offer you support that is fast and tai-

lored to your specific needs! 
Our Online Support on the Internet: 
www.siemens.com/gigasetcustomercare 
This site can be accessed at any time wher-

ever you are. It will give you 24/7 support 

for all our products. It also provides inter-

active troubleshooting, a list of FAQs and 

answers plus user guides for you to down-

load. You will also find frequently asked 

questions and answers in the Questions 

and Answers section of this user guide in 

the appendix. 
If you need to examine the phone, require 

assistance operating it or wish to make 

claims under the warranty, please call 

NewPan on 1 700700 727.
If you did not purchase the phone from an 

authorized dealer, we will not entertain 

any claims made under the warranty.

This product is designed for world-wide 

operation, depending on national 

approval outside the European Economic 

Area (except Switzerland). Country-spe-

cific conditions have been taken into 

account. The CE mark attests to the 

phone's compliance with the essential 

requirements of the R&TTE directive.

The display is blank. 
1. The handset is not switched on.

¥

Press the 'end call' key 

a

 and hold.

2. The battery is flat.

¥

Charge the battery or replace it (page 5).

The handset does not respond to a key press. 
The keypad lock is activated.

¥

Press the hash key 

#

 and hold (page 6).

 "Base x“ flashes in the display.
1. The handset is outside the range of the 

base.

¥

Move the handset closer to the base.

2. The handset has been de-registered.

¥

Register the handset (page 5).

3. The base is not switched on.

¥

Check the base's mains adapter (page 4).

Handset does not ring. 
The ringer is switched off.

¥

Activate the ringer (page 14).

The other party cannot hear you. 
You have pressed the 

u

 (

§INT§

) key. The hand-

set is "muted".

¥

Switch on the microphone again (page 9).

You hear an error tone when keying an input 
(a descending sequence of tones).
Action has failed/invalid input. 

¥

Repeat the operation. 
Watch the display and refer to the operating 

instructions if necessary.