Enterasys Networks 4H4284-49 User Manual

Page of 90
Installation Site Requirement
3-2 Installation
Installation Site Requirement
The DFE‐Gold module must be installed in a Matrix E7, N1, N3, N5, or N7 chassis located 
in a Restricted Access Location (RAL). This location should only be accessible by people 
that have been trained or are technically competent enough to be aware of potential risks 
of accessing the hazardous areas of the chassis. Locations such as a locked wiring closet or 
locked cabinet meet this requirement. 
Unpacking the DFE-Gold Module
Unpack the DFE‐Gold module as follows:
1.
Open the box and remove the packing material protecting the DFE‐Gold module.
2.
Verify the contents of the carton as listed in 
.
3.
Remove the tape seal on the non‐conductive bag to remove the DFE‐Gold module.
4.
Perform a visual inspection of the DFE‐Gold module for any signs of physical 
damage. Contact Enterasys Networks if there are any signs of damage. Refer to 
on page xviii for details.
Warning: Install this module in a Matrix E7, N1, N3, N5, or N7 chassis that has been 
installed in a Restricted Access Location only. Access to the equipment by users must be 
restricted through the use of a tool or lock and key or other means of security and is 
controlled by the authority responsible for the location. 
Advertencia: Instalar este modulo en un Matrix E7, N1, N3, N5, o N7 que ha sido 
localizado en un lugar de Acceso Restringido. Aceso al equipo debe ser restringido por el 
responsable del sitio.
Warnhinweis: Installieren Sie dieses Modul nur in einem E7, N1, N3, N5, oder N7 
Chassis, wenn sich diese in einer zugangsgeschützten Umgebung befinden. Der Bereich 
zu den Komponenten sollte durch ein Schloß, einen Schlüssel oder sonstigen 
Sicherungen geschützt und durch einen Verantwortlichen kontrolliert werden. 
Table 3-1 Contents of DFE-Gold Module Carton
Item
Quantity
DFE-Gold module 1
Installation Guide
1
Customer Release Notes
1