Estate tgs325mq Installation Instruction

Page of 16
11
GAS CONVERSIONS
LP Gas Conversion
To Convert Gas Pressure Regulator
1. Ensure that the manual shutoff valve is in the closed position 
and the power supply cord is unplugged.
2. Remove storage drawer or warming drawer. Locate gas 
pressure regulator at rear of storage or warming drawer 
compartment.
NOTE: On models with a warming drawer, an access cover 
must be removed from the gas pressure regulator.
IMPORTANT: Do not remove the gas pressure regulator.
Gas pressure regulator
3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap counterclockwise with a 
⁵⁄₈" 
combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
5. Turn over the gas pressure regulator cap and reinstall on 
regulator so that the hollow end faces out and the marking 
“<- LP” is facing the direction shown in the above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Standard Surface Burners
1. Remove burner cap. 
2. Using a Quadrex or Phillips screwdriver, remove the burner 
base.
NOTE: Reinstall one of the screws through the range cooktop 
to hold the orifice spud holder in place while removing and 
replacing the orifice spuds.
A. To range
B. Manual shutoff valve “closed” position
C. Gas supply line
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure 
gas pressure does not exceed 14" (36 cm) water 
column. 
Examples of a qualified person include: 
licensed heating personnel, 
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death 
or serious burns to children and adults.
A
B
C
A. Gas pressure regulator
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C. Gas pressure regulator cap with hollow end facing out
D. Washer
E. Gas pressure regulator cap
A
A
B
C
D
Side view before
Side view after
E
NG
LP
NG
LP