Enviro cara dr 50-1628 User Manual

Operating Instructions

For Your Safety, Read Safety Precautions And Lighting Instructions Before Operating.

WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY A FIRE OR EXPLOSION MAY

RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY OF LOSS OF LIFE.

Figure 2: Lighting Instruction Label.

2. Start the pilot by pressing the gas control knob and turning it to PILOT.

While holding the gas control knob in, press the piezo ignitor several

times until the pilot light starts. Hold the gas control knob in for 30

seconds. Check that the pilot has fully engulfed the thermocouple

assembly (refer to Figure 6).

3. Start the main burner by turning the gas control knob to ON and then

turn the rocker switch to ON. Check that all burner ports have flame.

4. Leak test all gas joints again.

Figure 3: Pilot Assembly.

1. Turn off the gas to the fireplace. If not recently done, remove the door and let the unit air out

for at least five (5) minutes to clear out any gas. Turn on gas to the heater. Leak test all joints

with soapy water. NEVER USE OPEN FLAME FOR LEAK TESTING.

CAUTION:

1. STOP! Read the safety information above on this label.
2. Turn off all electrical power to this appliance.
3. Turn off the gas control knob clockwise

to the off position.

4. Open door. Wait fIve (5) minutes to clear out any gas. Close door. If

you smell gas STOP! Follow “B” in the above safety information.

If you do not smell gas go to the next step.

5. Find pilot-located to the left behind the side log.

Turn the gas control knob counter-clockwise

“PILOT”. Push the gas control in fully and hold, keep knob

depressed for about 30 seconds after the pilot is lit.

Release knob. If pilot goes out, repeat steps 4 through 5.

Hot while operating. Do not touch, severe burns may result.

Keep children, clothing, furniture, gasoline or other flammable vapors away.

FOR YOUR SAFETY READ BEFORE OPERATING

WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING

PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.

A) This appliance is equipped with a pilot, which must be lit by hand by

following these instructions exactly.

B) BEFORE LIGHTING smell all around the appliance area for gas and next to

the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance. Do not touch any electrical switch: do not

use any phone in your building. Immediately call your gas supplier from a

neighbor's phone. Follow the gas suppliers instructions. If you cannot reach

your gas supplier, call the fire department.

C) Use only your hand to push in or turn the gas control knob; NEVER

use tools. If the knob will not push in or turn by hand, do not try to

repair it. Call a qualified service technician. Force or attempted repair

may result in a fire or explosion.

D) Do not use this appliance if any part has been under water.

Immediately call a qualified service technician to inspect the appliance

and to replace any part of the control system and any gas control

which has been under water.

LIGHTING INSTRUCTIONS

WARNING: This gas valve has a lockout device, which will not allow the

pilot burner to be relit until the thermocouple has cooled. If the knob does

does not pop up when released, stop and immediately call your service

technician or gas supplier. If the pilot does not stay lit after several tries,

turn the gas control knob to “OFF” and call your service technician

or gas supplier.

6. Turn the gas control knob counter clockwise

to the “ON” position.

Flip the burner switch to “ON” THEN

TURN THE “HI/LOW” knob to the

desired setting.

7. Turn on the electrical power to the unit.

TO TURN OFF GAS TO APPLIANCE

1. Flip burner switch to “OFF”

2. Turn the gas control knob clockwise

to the “OFF” position.

3. Turn off all electrical power to the appliance if service is to be

performed.

CAUTION: Do not operate this fireplace with the glass removed, cracked or broken. Replacement of the glass should be done by a licensed

or qualified person! This appliance needs fresh air for safe operation and must be installed with provisions for combustion and ventilation air.

See installation and operating instructions manual. Keep burner and control compartment clean.
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage, or loss of life. Refer

to owner's manual provided with this appliance. See installation and operating instructions accompanying appliance. Installation and service

must be performed by a qualified installer, service agency, or the gas supplier.

L I

T O

ILOT

IGHTING

NSTRUCTIONS