Alliance Laundry Systems 70269701R4 User Manual

61

70269701

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

The door switch should be adjusted so the cylinder 
stops when door is opened 2 inches (51 mm) plus or 
minus 0.25 inch (6 mm). This switch is a normally 
open switch and is closed by the hinge cam when the 
door is closed. If adjustment is required, refer to 
Figure 16 and proceed as follows:

1. Close door and start tumbler, slowly open 

loading door. Cylinder and heat system should 
shut off when door is open 2 inches (51 mm) plus 
or minus 0.25 inch (6 mm).

2. Slowly close the loading door. When door is 

2 inches (51 mm) from being fully closed, the 
door switch actuating bracket (located on the 
door) should depress the button and the switch 
arm with an audible “click.”

3. If the actuating bracket does not operate the 

switch at the appropriate door closure, bend the 
actuating switch arm in or out to achieve proper 
actuation.

CE tumblers have a second door switch near the top of 
the door (refer to Figure 16). This switch also should 
be adjusted so cylinder stops when door is opened 
within 0 – 2 inches (0 – 51 mm). This switch is 
normally closed and is opened by the hinge cam when 
the door is opened. If adjustment is needed, refer to 
Figure 16 and proceed as follows:

1. Remove lower switch actuator (Figure 16) so 

upper switch “click” can be heard.

2. Loosen upper door switch screws just enough so 

switch can be moved left and right. Move switch 
right if door opens too far before switch clicks. 
Move switch left if door doesn’t open far enough 
before switch clicks.

3. Retighten door switch screws and retest. Repeat 

step 2 if further adjustment is needed.

4. Reinstall lower switch actuator and retest its 

switch.

Figure 16 

T386I

CE Tumblers Only

Lower Switch Actuator