Alliance Laundry Systems SWD439C User Manual

800937

8

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

For most installations, the basic tools you will need 
are:

Figure 1 

Washer needs two standard 3/4 in. (19.1 mm) water 
supply faucets with a pressure between 20 and 
120 pounds per square inch (138 to 827 kPa). For more 
detailed information, refer to section on Water Supply 
Requirements.

Dryer is equipped for Natural Gas with a 3/8 in. N.P.T. 
gas supply connection. For more detailed information, 
refer to section on Gas Requirements.

Place the unit on a solid floor with an adequate air 
supply. For more detailed information, refer to section 
on Location Requirements.

Use rigid metal duct and exhaust the dryer to the 
outside by the shortest route possible. 

NOTE: For more detailed information, refer to 
section on Dryer Exhaust Requirements.

Figure 2 

●

WASHER 
Refer to serial plate for specific electrical 
requirements. For more detailed information, 
refer to section on Washer Electrical 
Requirements.

●

ELECTRIC DRYER
Dryer needs a 3 or 4 wire 120/240 or 120/208 Volt, 
60 Hertz, 30 Amperes, AC single phase electrical 
supply. For more detailed information, refer to 
section on Electric Dryer Electrical 
Requirements.

●

GAS DRYER
Dryer needs a 120 Volt, 60 Hertz, 15 Amperes, 
polarized 3-slot effectively grounded receptacle. 
For more detailed information, refer to section on 
Gas Dryer Electrical Requirements.

D814I

Wrench

Screwdrivers

Pliers

Socket Wrench

Teflon Tape

Level

Duct Tape

SWD442N