Agri-Fab 45-0361 User Manual
19
CUSTOMER RESPONSIBILITIES
INNER NUT
OUTER NUT
SWITCH
BODY
BODY
CLUTCH LEVER
1/8"
ENGINE
PULLEY
PULLEY
BLADE
PULLEY
PULLEY
IDLER
PULLEY
PULLEY
CLUTCH LEVER
PLUNGER
REAR DRIVE
COVER
COVER
FOUR
SCREWS
SCREWS
CLUTCH CABLE ADJUSTMENT
• Remove four screws from Rear Drive Cover. Lay aside
cover and screws.
• Place Clutch Lever in "DISENGAGED" position
• The Cable should be under slight tension but should
• The Cable should be under slight tension but should
not pull the Clutch Lever more than 1/8" away from
the Switch Body.
the Switch Body.
NOTE: If the Plunger extends more than 1/8" out from
the switch body, the cable tension is too tight and the
Engine will not start.
the switch body, the cable tension is too tight and the
Engine will not start.
TO INCREASE CABLE TENSION
• Place Blade Clutch Lever in the "DISENGAGED"
position.
• Loosen the inner nut on the Clutch Cable.
• Tighten the outer nut on the Clutch Cable.
• Tighten the outer nut on the Clutch Cable.
TO DECREASE CABLE TENSION
• Place Blade Clutch Lever in the "DISENGAGED"
position.
• Loosen the outer nut on the Clutch Cable.
• Tighten the inner nut on the Clutch Cable.
• Repeat the above procedure until you have the
• Tighten the inner nut on the Clutch Cable.
• Repeat the above procedure until you have the
correct tension.
CL
•
•
•
•
NO
the
Eng
the
Eng
TO
•
•
•
•
TO
•
•
•
•
•
•