Agri-Fab 45-0361 User Manual

CUSTOMER RESPONSIBILITIES

V-BELT REPLACEMENT

• V-belt must be replaced if it becomes stretched to

the point that it can no longer be adjusted, or if it
becomes frayed or otherwise can not function
properly.

• Move Blade Clutch Lever to the "DISENGAGED"

position.

INSTALLING NEW V-BELT

• Feed new V-belt between the two belt guides at the

Engine Pulley.

• Place V-belt up and around the Engine Pulley. Check

to make sure the V-belt is seated properly in the
groove of the Engine Pulley.

• Place V-belt along inside of Idler Pulley.
• Wrap V-belt down around Blade Pulley, placing Belt

inside of Rear Belt Guides.

• Reinstall V-belt Keeper Rod and secure with Small

Hair Pin. Check to make sure V-belt is over top of
Keeper Rod.

• Reposition and retighten two Rear Belt Guides at the

rear of the Blade Pulley. Leave approximately 1/16"
between Guides and Pulley.

• Reinstall Clevis Pin and Hair Pin into Clutch Cable.
• Reinstall Front Drive Cover and Rear Drive Cover.

REMOVING OLD V-BELT
• Remove Rear Drive Cover.
• Remove Front Drive Cover.
• Remove Hair Pin and Clevis Pin from Clutch Cable.
• Loosen two Rear Belt Guides and pivot them away

from Blade Pulley.

• Remove V-belt from around Blade Pulley.
• Remove one small Hair Pin from Belt Keeper Rod

and slide Belt Keeper Rod to the side.

• Pull V-belt down from around Engine Pulley and

remove V-belt from Mower.

CAUTION:
DISCONNECT SPARK PLUG WIRE

BELT GUIDES

ENGINE PULLEY

BELT KEEPER ROD

V-BELT

REAR BELT GUIDES

BLADE PULLEY

HAIRPIN AND CLEVIS PIN