Siemens m101 User Manual

appendix.fm5

16.4.99

Gigaset V.24 Adapter dt/eng:A30853-X400-B104-3-74D1 

This section describes settings, implementation options and 

programming methods.

Please note that

●

Only one connection can be active.

●

Only one "Teilnehmer" station type can be registered at a 

base that is ready for registration.

●

The station type for Gigaset M101 Data units is set to "Basis" 

by default.

Perform registration as described in the section "Initial configu-

ration" on page 11.

The Gigaset unit connected to the PC is called "Gigaset 1" and 

is the lokale Station. It is now an Teilnehmer station type and 

your Gigaset 2 (Partnerstation) is a Basis. Configure the trans-

mission parameters that are required for a connection between 

Gigaset 1 and Gigaset 2.

Change to the Local station tab and click Change station type, 

your Gigaset 1 is now a base.

Exit the configuration program and connect Gigaset 3 to the 

COM port. 

Now start the "Gigaset M101 Data > Set Gigaset" configuration 

program and switch to the Local station tab. Click Change sta-

tion type. Gigaset 3 is now an "Teilnehmer".

Press the black button on Gigaset 1 (station type currently Ba-

sis) for 10 s. The LEDs start to blink alternately, the base is ready 

for registration.

Click Register, enter the PIN (factory default "0000") and click 

OK. You have now registered Gigaset 3 (as an extension) at 

Gigaset 1 (the base).

Configure the transmission parameters that are required for a 

connection between Gigaset 3 and Gigaset 1. Exit the configu-

ration program.

Connect Gigaset 1 to the COM port at the PC that you want to 

use for bothway operation.

Teilnehmer

Basis

Basis

Basis

Teilnehmer

Basis