Siemens m101 User Manual

appendix.fm5

16.4.99

Gigaset V.24 Adapter dt/eng:A30853-X400-B104-3-74D1 

Configuration program displays 

the message "A Gigaset M101 

Data could not be found".

The COM port used is being 

used by another program. 

Close the application that is us-

ing the COM port.

Configuration on an Apple Mac-

intosh with "Virtual PC" is not 

working. 

The Mac interface is an RS422 

interface. In RS232 mode for 

this interface, the DTR signal re-

quired by the configuration pro-

gram to detect the Gigaset 

M101 Data is missing.

Configure Gigaset M101 Data 

correctly at an IBM-compatible 

PC and the install it down-

stream of the Apple Macintosh.

Configuration program displays 

the message "Could not register 

at the base". 

The base may not have been 

ready for registration or there 

was temporary interference on 

the radio link due to "external in-

fluences". 

Repeat registration at a base 

that is ready for registration. To 

do this, enter the PIN (factory 

default "0000"). See "Register-

ing an Teilnehmer station" on 

page 17.

The PIN entered is rejected.

The PIN entered does not 

match the valid PIN.

If you have forgotten the current 

PIN, reset the Gigaset M101 

Data unit to the factory default. 

The default PIN is "0000". See 

"Resetting the device to the fac-

tory default" on page 19.

PC-PC direct cable connection 

under WIN95 cannot be config-

ured or is not working. 

Baud rate not correctly set.

For information, see "PC -

PC direct cable connection: via 

RS232/V.24 interface" on page 

25.

Fax function is not working.

SW and modem simulate a 

Class1 fax.

Class 1 fax mode not supported 

for technical reasons by Gigaset 

M101 Data. Gigaset M101 Data 

supports Class 2 fax mode.

For information on additional setting options, see the modem 

manual or fax software description. (The AT command 

AT+FCLASS=? is useful, providing this is supported by the mo-

dem. If there is a 2 in the answer string, your modem supports 

Class 2 fax mode) 

Programs that use DCD (Data 

Carrierer Detect) are not work-

ing properly.

The DCD output of the local sta-

tion is controlled by the DCD in-

put of the remote station.

Use the null-modem cable at 

the remote station.