at-international tl32300 User Manual

2

Install the telephone base and charger as shown below. If you subscribe 
to high-speed Internet service (DSL - digital subscriber line) through your 
telephone line, you must install a DSL filter between the telephone line cord 
and the telephone wall jack. The filter prevents noise and caller ID problems 
caused by DSL interference. Please contact your DSL service provider for 
more information about DSL filters.

The telephone base comes ready for tabletop use. If you want to mount 
your telephone on a wall, refer to 

Wall mount installation in the user’s 

manual for details.

Telephone base and charger installation

Use only the power adapters provided with 
this product. To obtain a replacement, visit our 
website at 

 

or call 

. In Canada, 

dial 

.

The power adapters are intended to be 
correctly oriented in a vertical or floor mount 
position. The prongs are not designed to hold 
the plug in place if they are plugged into a 
ceiling or an under-the-table or cabinet outlet.

•

•

Raise the antenna.

Plug the large end 
of the smaller power 
adapter into an 
electrical outlet not 
controlled by a  
wall switch.

Ensure the small end 
of the smaller power 
adapter is plugged into 
the power jack on the 
back of the charger.

Route the cord through 
the slot.

Telephone line cord

A DSL filter (not included) 
is required if you have 
DSL high-speed Internet 
service.

Telephone wall jack

Electrical outlet not 
controlled by a wall 
switch

Plug the small end 
of the larger power 
adapter into the power 
jack on the back of the 
telephone base.

Plug the large end 
of the larger power 
adapter into an 
electrical outlet not 
controlled by a wall 
switch.

Plug one end of the 
telephone line cord 
into the 

TEL. LINE jack 

on the back of the 
telephone base.

Plug the other end of 
the telephone line cord 
into a telephone wall 
jack.

Route the cords 
through the slot.